SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA RWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1537 (INTERIOR TRIM)REPAIR INSTRUCTIONSASSIST HANDLE REPLACEMENTINSTALLATION PROCEDURE
2004 Oldsmobile Bravada RWD

Installation Procedure

2004 Oldsmobile Bravada RWDSECTION Installation Procedure
WARNING: This page is about a different car, the 2003 Oldsmobile Bravada, 2003 GMC Envoy XL, 2003 GMC Envoy, and 2003 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the bezels to the headliner.
  2. Rotate the bezels in order to seat the bezel retaining tabs above the headliner.
  3. Install the front and rear roof panel tabs into the bezels.
    4. Fig 1: Front And Rear Roof Panel Tabs Into Bezels
    G01642088Courtesy of GENERAL MOTORS CORP.
  4. Ensure the top of the roof panel tab (2) is positioned over the plastic retaining tab (1).
    5. Fig 2: Top Of Roof Panel Tab Is Positioned Over Plastic Retaining Tab
    G01642089Courtesy of GENERAL MOTORS CORP.
  5. Using a flat bladed tool, carefully push up on the bottom of the front roof panel tab (1) until fully seated.
    6. Fig 3: Push Up On Bottom Of Front Roof Panel Tab Until Fully Seated
    G01642090Courtesy of GENERAL MOTORS CORP.
  6. Using a flat bladed tool, carefully push on the bottom of the rear roof panel tab until fully seated.
  7. Close the bezel covers.
  8. Pull downward on the assist handle to ensure the handle is fully secured to the roof panel.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.