Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA RWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1525 (THEFT DETERRENT SYSTEM)
2004 Oldsmobile Bravada RWD
Section 1525 (Theft Deterrent System)
2004 Oldsmobile Bravada RWDSECTION Section 1525 (Theft Deterrent System)
WARNING: This page is about a different car, the 2003 Oldsmobile Bravada, 2003 GMC Envoy XL, 2003 GMC Envoy, and 2003 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
- Schematic and Routing Diagrams
- Component Locator
- Diagnostic Information and Procedures
- Diagnostic Starting Point - Theft Deterrent
- Diagnostic System Check - Theft Deterrent
- Scan Tool Data List
- Scan Tool Data Definitions
- Diagnostic Trouble Code (DTC) List
- DTC B2945: Short To Ground Or Open On The Passlock™ Sensor Power Circuit
- DTC B2955: BCM Signal Input Voltage
- DTC B2960: Sec Sys Sensor Data Incorrect But Valid
- DTC B3033: BCM Is Reading A Tamper Code From The Passlock™ Sensor
- DTC P1626: Theft Deterrent Fuel Enable Signal Not Received
- DTC P1630: Theft Deterrent Learn Mode Active
- DTC P1631: Theft Deterrent Start Enable Signal Not Correct
- DTC P1632: Theft Deterrent Start Disable Signal Received
- Symptoms - Theft Deterrent
- Content Theft Deterrent (CTD) Alarm Mode Inoperative
- Content Theft Deterrent (CTD) Does Not Disarm with Key Lock
- Horn Inoperative in Content Theft Deterrent (CTD) Alarm Mode
- Lights Inoperative in Content Theft Deterrent (CTD) Alarm Mode
- Security Indicator Always On or Flashing
- Security Indicator Inoperative
- Repair Instructions
- Description and Operation
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.