Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA RWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1500 (FRONT SUSPENSION SYSTEM)SPECIFICATIONSFASTENER TIGHTENING SPECIFICATIONS
2004 Oldsmobile Bravada RWD
Fastener Tightening Specifications
2004 Oldsmobile Bravada RWDSECTION Fastener Tightening Specifications
WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
Fastener Tightening Specifications
| Application | Specification | |
|---|---|---|
| Metric | English | |
| Crossmember Mounting Nuts (Use New Nuts) | 110 N.m | 81 lb ft |
| Lower Control Arm Ball Joint Stud Nut | ||
|
30 N.m | 20 lb ft |
|
180 degrees | |
| Power Steering Gear Mounting Bolts | 100 N.m | 74 lb ft |
| Shock Absorber Lower Mounting Nuts | 28 N.m | 21 lb ft |
| Shock Absorber Upper Mounting Nut | 26 N.m | 19 lb ft |
| Stabilizer Shaft Insulator Clamp Bolts | 58 N.m | 43 lb ft |
| Stabilizer Shaft Link Nuts | 72 N.m | 53 lb ft |
| Transverse Spring Retainer Bolts (Use New Bolts) | 62 N.m | 46 lb ft |
| Upper Control Arm Ball Joint Stud Nut | ||
|
20 N.m | 15 lb ft |
|
250 degrees | |
| Upper Control Arm Mounting Bolts | 65 N.m | 48 lb ft |
| Wheel Hub/Bearing Mounting Bolts | 130 N.m | 96 lb ft |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.