Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Scan Tool Data List
Use the Scan Tool Data Display Values and Definitions Information in order to assist in diagnosing the Instrument Panel Integration Module (IPM) problems. Compare the vehicles actual scan tool data with the typical data display value table information. Use the data information in order to aid in understanding the nature of the problem when the vehicle does not match with the typical data display values.
The scan tool data values were taken from a known good vehicle under the following conditions:
- The ignition switch is in the ON position.
- The engine is running at idle.
- The vehicle is in PARK.
- The doors are closed.
- The windows are closed.
- The A/C is ON.
- The ambient air temperatures are at 22-27°C (70-80°F).
| Scan Tool Parameter | Data List | Units Displayed | Typical Data Value |
|---|---|---|---|
| Operating Conditions: Engine idling, A/C ON, ambient air temperature between 22-27°C (70-80°F) | |||
| HVAC Bulb Illumination | Data | Percentage | 15-99% |
| Scan Tool Parameter | Data List | Units Displayed | Typical Data Value |
|---|---|---|---|
| Operating Conditions: Engine idling, A/C ON, ambient air temperature between 22-27°C (70-80°F) | |||
| A/C Button | Inputs | On/Off | Off |
| Auto Button | Inputs | On/Off | Off |
| Calibration ID | Module Information | 8-digit alphanumeric | AE017509 |
| Desired Blower Mtr Speed | Data | Counts | 15-111 Counts |
| Driver Temp Dial | Data | °C/°F | 15- 31°C/59-89°F |
| Fan Down Button | Inputs | Off/On | Off |
| Fan Up Button | Inputs | Off/On | Off |
| Front Defrost Button | Inputs | Off/On | Off |
| Inside Temp Sensor | Data | Volts | 2.3Volts |
| LH Mix Mtr Position Feedback | Data | Counts | 3-252 Counts |
| LH Mix Mtr Position Requested | Data | Counts | 1-254 Counts |
| Mix Motor State | Data | Normal/Fault | Normal |
| Mode Button | Inputs | Off/On | Off |
| Off Button | Inputs | Off/On | Off |
| Outside Air Button | Inputs | Off/On | Off |
| Outside Temp Sensor | Data | Volts | 1.7 Volts |
| Passenger Temp Dial | Data | Counts | 26-80 Counts |
| Rear Defrost Button | Inputs | Off/On | Off |
| Recirculate Button | Inputs | Off/On | Off |
| RH Mix Mtr Position Feedback | Data | Counts | 22-251 Counts |
| RH Mix Mtr Position Requested | Data | Counts | 1-254 Counts |
| Rom ID | Module Information | 8-digit alphanumeric | AE017414 |
| ROM Part Number | Module Information | 6-digit alphanumeric | 8F2259 |
| Sun Load Sensor | Data | Volts | 4.3 Volts |
| Vacuum Solenoid 1 | Data | Off/On | varies |
| Vacuum Solenoid 2 | Data | Off/On | varies |
| Vacuum Solenoid 3 | Data | Off/On | varies |
| Vacuum Solenoid 4 | Data | Off/On | varies |
| Vacuum Solenoid 5 | Data | Off/On | varies |
| Scan Tool Parameter | Data List | Units Displayed | Typical Data Value |
|---|---|---|---|
| Operating Conditions: Engine idling, A/C ON, ambient air temperature between 22-27°C (70-80°F) | |||
| A/C High Side Pressure | Engine Data 2 | kPa/psi | 965 kPa/140 psi |
| A/C High Side Pressure | Engine Data 2 | Volts | 1.65 Volts |
| A/C Relay Command | Engine Data 1/Engine Data 2/Misfire Data | On/Off | On |
| A/C Request Signal | Engine Data 1/Engine Data 2/Enhanced EVAP Data | Yes/No | Yes |
| A/C Clutch Feedback Signal | Engine Data 2 | On/Off | On |
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.