Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA RWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1467 (TIRE PRESSURE MONITORING SYSTEM)DIAGNOSTIC INFORMATION AND PROCEDURESSCAN TOOL DATA LIST
2004 Oldsmobile Bravada RWD
Scan Tool Data List
2004 Oldsmobile Bravada RWDSECTION Scan Tool Data List
WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
Scan Tool Data List
| Scan Tool Parameter | Data List | Units Displayed | Typical Data Value |
|---|---|---|---|
| Ignition ON/ Engine OFF/ Tire pressures set to specification | |||
| LF Tire Pressure | Tire Pressure Data | psi | 30 |
| LF Tire Status | Tire Information | Data Pending/OK | OK |
| LR Tire Pressure | Tire Pressure Data | psi | 30 |
| LR Tire Status | Tire Information | Data Pending/OK | OK |
| Manual Tire Programing | Tire Information | Active/Inactive | Inactive |
| RF Tire Pressure | Tire Pressure Data | psi | 30 |
| RF Tire Status | Tire Information | Data Pending/OK | OK |
| RR Tire Pressure | Tire Pressure Data | psi | 30 |
| RR Tire Status | Tire Information | Data Pending/OK | OK |
| Tire Pressure Sensor ID | Tire Information | Valid/Invalid | Valid |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.