Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Removal Procedure
2004 Oldsmobile Bravada RWDSECTION Removal Procedure
WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the module from the fuel tank. Refer to Fuel Tank Module Replacement - Left .
- Press on the connector position assurance (CPA) with thumb and slide toward downward.
- Disconnect the electrical connector from the module.
- Remove the sender wires from the connector.
- Push in the locktab above the level sender body and slide the level sender out of the slot.
- Remove the level sender from the module. Ensure wires are routed into the slot in the back of the level sender body.
IMPORTANT:
DO NOT handle the level sender on the resistor card. Oils from human contact can damage the card.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.