Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA RWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1448 (BATTERY, CHARGING SYSTEM & STARTING SYSTEM)REPAIR INSTRUCTIONSBATTERY POSITIVE FUSE BLOCK CABLE REPLACEMENTINSTALLATION PROCEDURE

2004 Oldsmobile Bravada RWD

Installation Procedure

2004 Oldsmobile Bravada RWDSECTION Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: I/P Wiring Harness Junction Block & Nut

Courtesy of GENERAL MOTORS CORP.

Install and route the fuse block cable through the front of dash.
Install the battery positive fuse block cable to the stud.
NOTE: Refer to Fastener Notice in Cautions and Notices.
Install the I/P wiring harness junction block nut.
Tighten: Tighten the I/P wiring harness junction block nut to 10 N.m (89 lb in).
Reposition the junction block nut boot.
Snap the junction block to the bracket.

Fig 2: Kick-Up Panel Latches & Multi-Use Relay Bracket

Courtesy of GENERAL MOTORS CORP.

Ensure the latches on the kick-up panel are open.
Insert the kick-up panel lower tabs into the slots in the bracket.
Close the panel and push the latches into the holes.

Fig 3: Fuse/Relay Center Stud & Positive Battery Cable Lead

Courtesy of GENERAL MOTORS CORP.

Install the battery positive fuse block cable to the stud.
Install the positive battery cable lead to the stud.
Install the positive battery cable nut (1).
Tighten: Tighten the positive battery cable nut to 10 N.m (89 lb in).
Close the stud cover on the fuse/relay center cover.
Install the battery tray. Refer to Battery Tray Replacement .

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.