Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Engine Electrical Component Views
2004 Oldsmobile Bravada RWDSECTION Engine Electrical Component Views
WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
| Callout | Component Name |
|---|---|
| 1 | Generator |
| 2 | Mass Air Flow (MAF) Sensor |
| Callout | Component Name |
|---|---|
| 1 | Starter |
| Callout | Component Name |
|---|---|
| 1 | Theft Deterrent Relay |
| 2 | Fuse Block-IP |
| 3 | Blower Motor Relay |
| 4 | Star Connector #2 |
| 5 | Body Control Module (BCM) C3 |
| 6 | Body Control Module (BCM) C1 |
| 7 | Star Connector #1 |
| 8 | Body Control Module (BCM) C2 |
| 9 | Steering Column Lock Relay |
| Callout | Component Name |
|---|---|
| 1 | Battery |
| 2 | Battery Cables |
| 3 | G104 |
| 4 | Engine Coolant Reservoir |
| 5 | Fuse Block-Underhood |
| Callout | Component Name |
|---|---|
| 1 | Stop Lamp Switch C1 |
| 2 | Stop Lamp Switch C3 |
| 3 | C213 |
| 4 | Bose Signal Processor |
| 5 | Accelerator Pedal Position (APP) Sensor |
| 6 | Accelerator Pedal |
| 7 | Brake Pedal |
| 8 | Steering Wheel Position Sensor |
| 9 | Clutch Pedal |
| 10 | Clutch Pedal Start Switch |
| 11 | Clutch Pedal Position Switch |
| 12 | Stop Lamp Switch |
| 13 | Stop Lamp Switch Connector C2 |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.