Installation Procedure

2004 Oldsmobile Bravada RWDSECTION Installation Procedure
WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. If replacing the roof retainer, install the roof retainer the roof panel ensuring the Z clips are fully seated.
  2. If installing the existing roof retainer, position the roof retainer to the roof panel.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  3. Partially install the 4 screws retaining the roof retainer to the Z clips.

    Tighten 

    Tighten the screws to 1 N.m (10 lb in).

  4. Install the headliner. Refer to Headliner Replacement .
    Fig 1: Installing Roof Console & Retainer Screws
    G01718970Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.