Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA RWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1442 (BATTERY)REPAIR INSTRUCTIONSBATTERY REPLACEMENTINSTALLATION PROCEDURE

2004 Oldsmobile Bravada RWD

Installation Procedure

2004 Oldsmobile Bravada RWDSECTION Installation Procedure

WARNING: This page is about a different car, the 2003 Oldsmobile Bravada, 2003 GMC Envoy XL, 2003 GMC Envoy, and 2003 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.

Install the battery.
NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
Install the battery hold down retainer (1), nut (3), and washer.
Tighten

Tighten the nut to 15 N.m (11 lb ft).

Fig 1: Installing Battery
Courtesy of GENERAL MOTORS CORP.
Install the battery cover.

Fig 2: Installing Battery Cover
Courtesy of GENERAL MOTORS CORP.
Install the battery tray brace bolts/nut.
Tighten

Tighten the bolts/nut to 10 N.m (89 lb in).

Fig 3: Installing Battery Tray Brace Bolts/Nut
Courtesy of GENERAL MOTORS CORP.
Install the battery air duct to the battery cover.

Fig 4: Installing Battery Air Duct To Battery Cover
Courtesy of GENERAL MOTORS CORP.
Install the coolant heater cord retainers (1) to the battery cover, if equipped.

Fig 5: Installing Coolant Heater Cord Retainers To Battery Cover
Courtesy of GENERAL MOTORS CORP.
Position the positive battery cable to the battery.
Tighten the positive battery cable bolt.
Tighten

Tighten the bolt to 15 N.m (11 lb ft).
Connect the negative battery cable. Refer to BATTERY NEGATIVE CABLE DISCONNECT/CONNECT PROCEDURE .

Fig 6: Positioning Positive Battery Cable To Battery
Courtesy of GENERAL MOTORS CORP.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.