Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA RWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1394 (TRANSFER CASE)REPAIR INSTRUCTIONSTRANSFER CASE REPLACEMENTREMOVAL PROCEDURE

2004 Oldsmobile Bravada RWD

Removal Procedure

2004 Oldsmobile Bravada RWDSECTION Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.

Remove the engine and transaxle from the vehicle. Refer to Engine Replacement in Engine Mechanical.
Place a drain pan or suitable container under the transfer case assembly.

Fig 1: Transfer Case Drain Plug And Gasket

Courtesy of GENERAL MOTORS CORP.

Remove the transfer case drain plug and gasket (1).
Drain the transfer case.

Fig 2: Engine Mount Bracket

Courtesy of GENERAL MOTORS CORP.

Remove the left rear engine mount bracket (1) from the engine block.

Fig 3: Transfer Case Bracket Bolts And Upper/Lower Bolts

Courtesy of GENERAL MOTORS CORP.

Remove the upper 2 bolts (1) from the transfer case bracket.
Remove the lower 3 bolts (3) from the transfer case bracket.
Remove the bracket from the transfer case.
Remove the 4 right transfer case bracket bolts (2), then remove the bracket from the transfer case.

Fig 4: Front/Rear Transfer Case Retaining Nuts

Courtesy of GENERAL MOTORS CORP.

Remove the 2 front transfer case retaining nuts (2).
Remove the 4 rear transfer case retaining nuts (1).
Using a soft faced hammer, gently dislodge the transfer case from the transaxle assembly.
Slide the transfer case horizontally to remove it from the mounting studs.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.