Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA RWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1386 (POWER STEERING SYSTEM)SPECIFICATIONSFASTENER TIGHTENING SPECIFICATIONS
2004 Oldsmobile Bravada RWD
Fastener Tightening Specifications
2004 Oldsmobile Bravada RWDSECTION Fastener Tightening Specifications
WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
Fastener Tightening Specifications
| Application | Specification | |
|---|---|---|
| Metric | English | |
| Engine Mount Bracket Bolts, Rear | 64 N.m | 47.2 lb ft |
| Engine Mount Insulator Bolt, Rear | 87 N.m | 64.2 lb ft |
| Outer Tie Rod End Nut | 49 N.m | 36.1 lb ft |
| Power Steering Gear Bolt, 2WD | 58 N.m | 42.8 lb ft |
| Power Steering Gear Bolt, 4WD | 82 N.m | 60.5 lb ft |
| Power Steering Pipe Bracket Bolt | 7.8 N.m | 69.04 lb in |
| Power Steering Pressure Pipe Nut | 23 N.m | 17 lb ft |
| Power Steering Pressure Switch | 21 N.m | 15.5 lb ft |
| Power Steering Pump Housing Bolts | 22 N.m | 16.2 lb ft |
| Power Steering Pump Inlet Tube Bolt | 12 N.m | 106.2 lb in |
| Power Steering Pump Nuts and Bolts | 37 N.m | 27.3 lb ft |
| Power Steering Pump Fitting | 69 N.m | 50.9 lb ft |
| Power Steering Pump Outlet Pipe Bracket Bolt | 7.8 N.m | 69.04 lb in |
| Power Steering Pump Outlet Pipe Fitting | 41 N.m | 30.2 lb ft |
| Power Steering Pump Rear Bracket Bolt | 37 N.m | 27.3 lb ft |
| Power Steering Return Pipe Nut | 23 N.m | 17.0 lb ft |
| Steering Column Intermediate Shaft Bolt | 35 N.m | 25.8 lb ft |
| Steering Shaft Coupling Bolts | 35 N.m | 25.8 lb ft |
| Tie Rod Lock Nut | 74 N.m | 54.6 lb ft |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.