Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA RWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 138 (ENGINE CONTROLS REMOVAL & INSTALLATION)FUEL SYSTEMS (CNG ENGINE)NOTES
2004 Oldsmobile Bravada RWD
Fuel Systems (CNG Engine): Notes
2004 Oldsmobile Bravada RWDSECTION Notes
WARNING: This page is about a different car, the 2002 Pontiac Sunfire and 2002 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Natural gas is highly flammable. To reduce risk of fire and personal injury, keep sparks, flames, and smoking materials away from vehicle while you perform Compressed Natural Gas (CNG) fuel system service. DO NOT allow fuel to contact engine or electrical components. CNG system operates at pressures up to 3600 psi (24,820 kPa). Release CNG fuel system pressure before servicing CNG fuel system components to reduce risk of fire and personal injury. Before servicing any electrical component, ignition must be in OFF or LOCK position and all electrical loads must be off, unless instructed otherwise in these procedures. If a tool or equipment could come in contact with a live exposed electrical terminal, also disconnect negative battery cable. Failure to follow these precautions may cause personal injury and/or damage to the vehicle or its components.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.