Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA RWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1378 (SUNROOF SYSTEM)COMPONENT LOCATORPOWER ROOF SYSTEMS CONNECTOR END VIEWS
2004 Oldsmobile Bravada RWD
Power Roof Systems Connector End Views
2004 Oldsmobile Bravada RWDSECTION Power Roof Systems Connector End Views
WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
Sunroof Switch Assembly Connector End View
| Connector Part Information |
|
|
|---|---|---|
| Pin | Wire Color | Function |
| 1 | BK | Battery Positive Voltage |
| 2 | BK | Ignition Positive Voltage |
| 3 | WH/BK | Map Lamp Ground |
| 4 | RD | Sunroof Motor Close Voltage |
| 5 | GN | Sunroof Motor Open Voltage |
| 6 | GN/WH | Sunroof Limit Switch 1 Signal |
| 7 | RD/BU | Sunroof Limit Switch 2 Signal |
| 8 | WH/BK | Ground |
Sunroof Motor Connector End View
| Connector Part Information |
|
|
|---|---|---|
| Pin | Wire Color | Function |
| 1 | RD | Sunroof Motor Close Voltage |
| 2 | GN | Sunroof Motor Open Voltage |
| 3 | WH/BK | Sunroof Motor Ground |
| 4 | WT/BK | Sunroof Limit Switch Ground |
| 5 | GN/WH | Sunroof Limit Switch 1 |
| 6 | RD/BU | Sunroof Limit Switch 2 |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.