SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA RWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1377 (STATIONARY WINDOW SYSTEM)REPAIR INSTRUCTIONSWINDSHIELD REPLACEMENTINSTALLATION PROCEDURE
2004 Oldsmobile Bravada RWD

Installation Procedure

2004 Oldsmobile Bravada RWDSECTION Installation Procedure
WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Upper Windshield Stoppers
    GM867289Courtesy of GENERAL MOTORS CORP.
  1. Replace the upper windshield stoppers (1) and (2).
  2. Install a stationary window into the opening. Refer to Urethane Adhesive Installation of Stationary Windows .
    3. Fig 2: Windshield Inside Garnish Molding
    GM241992Courtesy of GENERAL MOTORS CORP.
  3. Install the air inlet grille. Refer to Air Inlet Grille Panel Replacement in Body Front End.
  4. Install the windshield wiper arms. Refer to Wiper Arm Replacement in Wipers/Washer Systems.
  5. Close the hood.
  6. Install the rearview mirror. Refer to Rearview Mirror Replacement .
  7. Install the windshield side garnish moldings (1). Refer to Garnish Molding Replacement - Windshield Pillar in Interior Trim.
  8. Remove the double layer of masking tape from around the perimeter of the painted surfaces and the interior trim.
  9. Close the door.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.