Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Section 137 (Engine Control System Troubleshooting - No Codes): Introduction
Before diagnosing symptoms or intermittent faults, perform appropriate DIAGNOSTIC SYSTEM CHECK - ENGINE CONTROLS in appropriate SELF-DIAGNOSTICS article. Use this article to diagnose driveability problems when a current DTC is not present.
Symptom checks are intended to direct the technician to malfunctioning component(s) so that further diagnosis may be performed. A symptom should lead to further testing of specific components or systems, or verification of adjustment specifications.
Use intermittent test procedures to locate intermittent driveability problems that do not occur when the vehicle is being tested. These problems may cause a noticeable driveability problem or cause the Malfunction Indicator Light (MIL) to illuminate on some vehicles.
It is also possible that certain driveability concerns have been rectified by the manufacturer through reprogramming the PCM. Check with manufacturer for latest information on updated programs.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.