Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA RWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1369 (ANTILOCK BRAKE SYSTEM)DIAGNOSTIC INFORMATION AND PROCEDURESSCAN TOOL DATA LIST
2004 Oldsmobile Bravada RWD
Scan Tool Data List
2004 Oldsmobile Bravada RWDSECTION Scan Tool Data List
WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
Scan Tool Data List
| Scan Tool Parameter | Data List | Units Displayed | Typical Data Value |
|---|---|---|---|
| Operating Conditions: Ignition ON, Engine OFF, Transmission in Neutral or Park, and Brake Unapplied | |||
| ABS Pump Motor | ABS | On/Off | Off |
| Brake Switch | ABS | Applied/Released | Released |
| Deceleration Sensor (AWD only) | ABS | Low/Middle/High | Low |
| Ignition Voltage | ABS | Volts | Varies |
| Left Front Wheel Speed | ABS | mph/km/h | 0 |
| Left Rear Wheel Speed | ABS | mph/km/h | 0 |
| LF Hold Solenoid | ABS | Active/Inactive | Inactive |
| LF Release Solenoid | ABS | On/Off | Inactive |
| LR Hold Solenoid | ABS | On/Off | Inactive |
| LR Release Solenoid | ABS | On/Off | Inactive |
| RF Hold Solenoid | ABS | On/Off | Inactive |
| RF Release Solenoid | ABS | On/Off | Inactive |
| Right Front Wheel Speed | ABS | mph/km/h | 0 |
| Right Rear Wheel Speed | ABS | mph/km/h | 0 |
| RR Hold Solenoid | ABS | On/Off | Inactive |
| RR Release Solenoid | ABS | On/Off | Inactive |
| Valve Relay State | ABS | On/Off | On |
| Vehicle Speed | ABS | mph/km/h | 0 |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.