Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Fuel Sender Assembly
| Callout | Component Name |
|---|---|
| 1 | Fuel Tank Pressure (FTP) Sensor |
| 2 | Fuel Sender Assembly Housing - Support |
| 3 | Fuel Level Sensor |
| 4 | Fuel Level Sender Wire Harness |
| 5 | Fuel Pressure Regulator O-ring |
| 6 | Fuel Pressure Regulator |
| 7 | Fuel Pump Strainer |
| 8 | Lower Cushion |
| 9 | Fuel Sender Assembly End Cap - Support |
| 10 | Retaining Clip |
| 11 | Fuel Pump |
| 12 | Fuel Pump O-ring |
| 13 | Fuel Filter and Housing |
| 14 | FTP Sensor Retaining Clip |
The fuel sender assembly is located in the fuel tank. The fuel sender assembly contains the electric fuel pump, the fuel level sensor, the fuel pressure regulator, and the fuel filter. Most of the fuel sender assembly components can be serviced separately.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.