Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Fastener Tightening Specifications
2004 Oldsmobile Bravada RWDSECTION Fastener Tightening Specifications
WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
Fastener Tightening Specifications
| Application | Specification | |
|---|---|---|
| Metric | English | |
| Accelerator Cable Adjusting Locknut | 8 N.m | 71 lb in |
| Accelerator Cable Attaching Fastener | 2 N.m | 18 lb in |
| Accelerator Cable-to-bulkhead Fastener | 15 N.m | 11 lb ft |
| Accelerator Pedal Bracket Fastener | 10 N.m | 89 lb in |
| Accelerator Pedal Cable-to-bulkhead Fastener | 15 N.m | 11 lb ft |
| Camshaft Position (CMP) Actuator Solenoid Valve Fastener | 9 N.m | 80 lb in |
| Camshaft Position (CMP) Actuator Solenoid Valve Oil Filter Plug | 30 N.m | 22 lb ft |
| Camshaft Position (CMP) Sensor Fastener | 8.8 N.m | 77 lb in |
| Crankshaft Position (CKP) Sensor Fastener | 8.8 N.m | 77 lb in |
| Engine Coolant Temperature (ECT) Sensor | 20 N.m | 15 lb ft |
| Engine Cover Plate Fastener | 7 N.m | 62 lb in |
| EVAP Canister Support Bracket Fastener | 19 N.m | 14 lb ft |
| EVAP Canister Vent Solenoid Valve Fastener | 8.8 N.m | 77 lb in |
| EVAP Pressure Switching Solenoid Valve Fastener | 8.8 N.m | 77 lb in |
| EVAP/Fuel Pipe Protector Fasteners | 1.2-2 N.m | 11-18 lb in |
| Fuel Filler Pipe Bracket Fastener | 30 N.m | 22 lb ft |
| Fuel Filler Pipe-to-Fuel Filler Pipe Bracket Fasteners | 6 N.m | 53 lb in |
| Fuel Injector Wire Harness Cover Plate Fastener | 16 N.m | 12 lb ft |
| Fuel Pipe Front Bulkhead Support Fastener | 6 N.m | 53 lb in |
| Fuel Rail Fastener | 19 N.m | 14 lb ft |
| Fuel Rail Inlet Pipe Hold Fastener | 9 N.m | 80 lb in |
| Fuel Sender Assembly Hold Down Plate Fastener | 6 N.m | 53 lb in |
| Fuel Tank-Rear Exhaust Heat Shield Fastener | 5.4 N.m | 48 lb in |
| Fuel Tank Retaining Strap Fastener | 39 N.m | 29 lb ft |
| Heated Oxygen Sensor (HO2S) 1 | 44 N.m | 32 lb ft |
| Heated Oxygen Sensor (HO2S) 2 | 44 N.m | 32 lb ft |
| Idle Air Control (IAC) Fasteners | 3.7 N.m | 33 lb in |
| Ignition Coil Fastener | 9 N.m | 80 lb in |
| Knock Sensor (KS) | 20 N.m | 15 lb ft |
| Mass Air Flow (MAF) Sensor Fasteners | 2.0 N.m | 18 lb in |
| Negative Battery Cable Terminal Retainer Fastener | 15 N.m | 11 lb ft |
| Parking Brake Cable Fasteners | 5.4 N.m | 48 lb in |
| Powertrain Control Module (PCM) Mounting Fastener | 15 N.m | 11 lb ft |
| Power Steering Pressure (PSP) Switch | 21 N.m | 15.5 lb ft |
| Spark Plug | 25 N.m | 18 lb ft |
| Throttle Body/Accelerator Cable Bracket Fastener | 13 N.m | 9.5 lb ft |
| Throttle Body Fastener | 30 N.m | 22 lb ft |
| Throttle Position (TP) Sensor Fasteners | 2.0 N.m | 18 lb in |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.