Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Removal Procedure
2004 Oldsmobile Bravada RWDSECTION Removal Procedure
WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
- Disable the SIR System. Refer to SIR Disabling and Enabling Zone 3 in SIR.
- Remove the following components from the steering column:
- The lower trim cover screw
- The 2 lower trim cover screws that are located beneath the steering wheel (3).
- Remove the steering column lower trim cover (6).
- Remove the steering column upper trim cover (7).
- Disconnect the wiper/washer switch electrical connector.
- Remove the wiper/washer switch (2) from the steering column, by depressing the tab (1).
CAUTION:
Refer to SIR Caution
in Cautions and Notices.
IMPORTANT:
It is not necessary to remove the steering wheel to access the lower trim cover screws. The screws can be easily accessed by rotating the steering wheel.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.