SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA RWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1327 (BODY FRONT END)REPAIR INSTRUCTIONSSUPPORT REPLACEMENT - CENTERINSTALLATION PROCEDURE
2004 Oldsmobile Bravada RWD

Installation Procedure

2004 Oldsmobile Bravada RWDSECTION Installation Procedure
WARNING: This page is about a different car, the 2003 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Refer to FASTENER NOTICE .
  1. Install the center support (2) to the vehicle. Secure the support with the 2 bolts.

    Tighten 

    Tighten the center support bolts to 15 N.m (11 lb ft).

    Fig 1: Installing Center Support & Bolts To Vehicle
    G01434567Courtesy of GENERAL MOTORS CORP.
  2. Install the input air temperature sensor (2) connector to the center support (1).
  3. Install the hood secondary catch and primary latch. Refer to HOOD LATCH REPLACEMENT   .
  4. Install the upper fascia plastic retainer to the top of the center support.
    Fig 2: Installing Input Air Temperature Sensor Connector To Center Support
    G01434568Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.