Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Fuel Sender Access Panel: Installation
2004 Oldsmobile Bravada RWDSECTION Installation
WARNING: This page is about a different car, the 2002 Pontiac Grand Prix, 2002 Chevrolet Monte Carlo, 2002 Chevrolet Impala, 2002 Buick Regal, and 2002 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
- Install the fuel sender access panel. Install the fuel sender access panel nuts. Tighten the nuts to specification. See TORQUE SPECIFICATIONS . Install the rear compartment trim panel to the rear compartment. See Fig 2.
- Unfold the trim panel sides and rear sections and press them into place. Install the spare tire. Install the spare tire cover in the rear compartment. Position the communication interface module and the bracket in the rear compartment. See Fig 1. Install the communications interface module bracket nuts. Tighten the bracket nuts to specification.
- Connect the GPS antenna cable by pushing in on the metal sleeve. Connect the two lower connectors to the module. Connect the cellular antenna by pressing in on the square plastic housing. Install the rear compartment mat in the rear compartment. Install the retainers by the rear compartment lock striker. Replace the lower rear compartment convenience net retainers. Install the rear compartment convenience net. Close the rear compartment.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.