Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
2004 Oldsmobile Bravada RWDSECTION Installation Procedure
WARNING: This page is about a different car, the 2003 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
- Position the stabilizer shaft on the crossmember.
- Install the 2 stabilizer shaft insulators to the stabilizer shaft.
- Install the 2 clamps and the 4 bolts to the insulators.
- Install the crossmember to the vehicle. Refer to FRONT SUSPENSION CROSSMEMBER REPLACEMENT (FWD)
or FRONT SUSPENSION CROSSMEMBER REPLACEMENT (AWD)
.NOTE: Refer to FASTENER NOTICE .
- Tighten the 4 bolts to the clamps.
Tighten
Tighten the bolts to 19 N.m (14.0 lb ft).
- Install the stabilizer shaft links and the nuts (1,2) to the stabilizer shaft and to the strut brackets.
Tighten
Tighten the nuts to 74 N.m (54.6 lb ft).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.