SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA RWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1292 (ANTI-LOCK BRAKE SYSTEM)REPAIR INSTRUCTIONSELECTRONIC BRAKE CONTROL MODULE (EBCM) REPLACEMENTREMOVAL PROCEDURE
2004 Oldsmobile Bravada RWD

Removal Procedure

2004 Oldsmobile Bravada RWDSECTION Removal Procedure
WARNING: This page is about a different car, the 2002 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: To prevent equipment damage, never connect or disconnect the wiring harness connection from the EBCM with the ignition switch in the ON position.
  1. Turn the ignition switch to the OFF position.
  2. Remove the fuel injector sight shield, 3.8 L engine only. Refer to FUEL INJECTOR SIGHT SHIELD REPLACEMENT (L36) or FUEL INJECTOR SIGHT SHIELD REPLACEMENT (L67) .
  3. Remove the front fender upper diagonal brace.

    Refer to BRACE REPLACEMENT -- SHEET METAL DIAGONAL .

  4. Disconnect the accelerator and cruise control cable from the accelerator control cable bracket.
  5. Disconnect the cruise control module from the left strut tower. It is not necessary to remove the cable from the module. Refer to CRUISE CONTROL MODULE REPLACEMENT . Position the module and cables aside.
    Fig 1: EBCM Harness Connector & Locking Tab
    G01673698Courtesy of GENERAL MOTORS CORP.
  6. Remove the air cleaner intake duct. Refer to AIR CLEANER INTAKE DUCT .
  7. Disengage the locking tab (1) from the EBCM harness connector.
  8. Disconnect the EBCM harness connector.
  9. Remove any dirt/debris from the assembly:
  10. Remove the six EBCM to BPMV retainers (2).
    IMPORTANT: Do not pry apart using a tool. Be careful not to damage BPMV surface.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.