SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA RWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1282 (BODY FRONT END)REPAIR INSTRUCTIONSHOOD LATCH SUPPORT REPLACEMENTINSTALLATION PROCEDURE
2004 Oldsmobile Bravada RWD

Installation Procedure

2004 Oldsmobile Bravada RWDSECTION Installation Procedure
WARNING: This page is about a different car, the 2003 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the hood latch support to the upper and lower tie bar.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the to the hood latch support to upper tie bar bolts.

    Tighten 

    Tighten the hood latch support upper tie bar bolts to 25 N.m (18 lbft).

  3. Install the hood latch support to lower tie bar nut.

    Tighten 

    Tighten the hood latch support to lower tie bar nut to 10 N.m (89 lb in).

  4. Install the hood latch to the hood latch support. Refer to HOOD LATCH REPLACEMENT  .
  5. Install the front bumper fascia upper support to the hood latch support. Refer to FASCIA SUPPORT REPLACEMENT - FRONT BUMPER UPPER in Bumpers.
    Fig 1: Installing Hood Latch Support
    G01503969Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.