Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
2004 Oldsmobile Bravada RWDSECTION Installation Procedure
WARNING: This page is about a different car, the 2003 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
- Install the wiper arms onto the wiper transmission.
- Hold the measuring device at a 90 degree angle to the wiper blade while maintaining the following distances:
- Right arm: 97-107 mm (3.82-4.21 in) from the end of the wiper arm to the air inlet screen.
- Left arm: 125-147 mm (4.92-5.78 in) from the wiper blade tip to the air inlet screen.
NOTE: Refer to FASTENER NOTICE in Cautions and Notices. - Install the wiper arm nut.
Tighten
Tighten the nut to 30 N.m (22 lb ft).
- Install the wiper arm nut cover.
- Connect the washer hose to the wiper arm.
- Operate the windshield wipers and inspect for proper operation.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.