Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA RWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1264 (BATTERY)SPECIFICATIONSFASTENER TIGHTENING SPECIFICATIONS
2004 Oldsmobile Bravada RWD
Fastener Tightening Specifications
2004 Oldsmobile Bravada RWDSECTION Fastener Tightening Specifications
WARNING: This page is about a different car, the 2003 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
Fastener Tightening Specifications
| Application | Specification | |
|---|---|---|
| Metric | English | |
| Battery Hold Down Bolt | 18 N.m | 13 lb in |
| Battery Negative Terminal Bolt | 15 N.m | 11 lb ft |
| Battery Positive Cable Junction Block Lead Nut | 10 N.m | 89 lb in |
| Battery Positive Terminal Bolt | 15 N.m | 11 lb ft |
| Battery Side Terminal Adapter | 15 N.m | 11 lb ft |
| Battery Tray Bolt | 5 N.m | 44 lb in |
| Generator Bolt 3.1 L | 50 N.m | 37 lb ft |
| Generator Bolt 3.8L | 50 N.m | 37 lb ft |
| Generator Brace Bolt 3.8L | 30 N.m | 22 lb ft |
| Generator Bracket Bolt 3.1L | 50 N.m | 37 lb ft |
| Generator Nut 3.1 L | 50 N.m | 37 lb ft |
| Generator Output BAT Terminal Nut | 20 N.m | 15 lb ft |
| Generator Pivot Bolt 3.1L | 50 N.m | 37 lb ft |
| Generator Rear Brace Bolt/Nut 3.8L | 50 N.m | 37 lb ft |
| Generator Rear Brace Nut/Stud 3.1L | 25 N.m | 18 lb ft |
| Generator Rear Bracket Bolt 3.8L | 50 N.m | 37 lb ft |
| Generator Stud 3.8L | 50 N.m | 37 lb ft |
| Ground Wire Bolt | 10 N.m | 89 lb ft |
| Starter Bolt | 43 N.m | 32 lb ft |
| Starter Solenoid BAT Terminal Nut | 10 N.m | 89 lb in |
| Starter Solenoid S Terminal Nut | 3 N.m | 27 lb in |
| Transaxle Stud Nut | 30 N.m | 22 lb ft |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.