Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
2004 Oldsmobile Bravada RWDSECTION Installation Procedure
WARNING: This page is about a different car, the 2003 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
- Install the gasket.
- Install the water pump.NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
- Install the water pump bolts.
Tighten
Tighten the bolts to 10 N.m (89 lb in).
- Install the water pump pulley.
- Install the water pump pulley bolts.
Tighten
Tighten the bolts to 25 N.m (18 lb ft).
- Install the drive belt. Refer to DRIVE BELT REPLACEMENT in Engine Mechanical - 3.1L.
- Install the drive belt shield and the bolt.
Tighten
Tighten the bolt to 10 N.m (89 lb in).
- Fill the cooling system. Refer to DRAINING AND FILLING COOLING SYSTEM .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.