Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA RWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1245 (ENGINE COOLING SYSTEM)REPAIR INSTRUCTIONSRADIATOR REPLACEMENTINSTALLATION PROCEDURE

2004 Oldsmobile Bravada RWD

Installation Procedure

2004 Oldsmobile Bravada RWDSECTION Installation Procedure

WARNING: This page is about a different car, the 2002 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.

Install the radiator to the lower mounts.
Lubricate the O-ring seal of the coolant level module with coolant.
Place the snap clip leg in place.
Install the coolant level module.
Connect the electrical connector to the coolant level module.

Fig 1: Radiator
Courtesy of GENERAL MOTORS CORP.
Install the transaxle oil cooler pipes.
IMPORTANT: Install new retaining rings into the quick connect fittings.
Ensure the following procedures are performed when installing the new retaining ring onto the fitting.

Fig 2: Transaxle Oil Cooler Pipes
Courtesy of GENERAL MOTORS CORP.
Hook one of the open ends of the retaining ring in one of the slots in the quick connect fitting.

Fig 3: Transaxle Oil Cooler Pipe Fitting Retaining Ring
Courtesy of GENERAL MOTORS CORP.
Rotate the retaining ring around the fitting until the retaining ring is positioned with all three ears through the three slots on the fitting.

Fig 4: Positioning Retaining Ring
Courtesy of GENERAL MOTORS CORP.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.