Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Camshaft Position Sensor: Installation
Ensure the CMP sensor bore is completely free of any foreign material, such as old "O" ring, dirt, burrs, etc. Ensure that the flange on the CMP sensor bore is not damaged. Clean all mounting surfaces before reinstalling any components. Lubricate the CMP sensor "O" ring with clean engine oil. Install CMP sensor. Tighten CMP sensor bolt to specification. See TORQUE SPECIFICATIONS . Connect CMP sensor connector. Position coolant recovery tank onto the mounting studs. Install coolant recovery tank mounting nuts.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.