Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Removal Procedure
2004 Oldsmobile Bravada RWDSECTION Removal Procedure
WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Refer to EXPRESS WINDOW DOWN CAUTION
in Cautions and Notices.
- Lower the door window.
- Remove the door trim panel. Refer to TRIM PANEL REPLACEMENT - DOOR .
- Remove the door radio speaker assembly.
- Remove the screws mounting the speaker assembly.
- Disconnect the electrical/audio connector.
- Remove the mirror nut access plugs.
- Disconnect the electrical connector(s).
- Disconnect the mirror harness from the retainers.
- Remove the nuts from the mirror studs.
- Remove the mirror with the harness and gasket.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.