Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
2004 Oldsmobile Bravada RWDSECTION Installation Procedure
WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Refer to FASTENER NOTICE
.
- Install the brake fluid pressure sensor to the EBCM in the vehicle.
Tighten
Tighten the switch to 22 N.m (16 lb ft).
- Connect the brake pressure sensor electrical connector.
- Reposition the EBCM to the support bracket and tighten the insulator nuts (1).
Tighten
Tighten the nuts to 12 N.m (106 lb in).
- Install and connect the radiator inlet hose.
- Fill the cooling system. Refer to DRAINING AND FILLING COOLING SYSTEM in Engine Cooling.
- Perform the DIAGNOSTIC SYSTEM CHECK - ABS .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.