Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Front Toe Adjustment
2004 Oldsmobile Bravada RWDSECTION Front Toe Adjustment
WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
- Loosen the jam nut on the tie rod (2).
- Rotate the inner tie rod (1) to the required toe specification setting. Refer to WHEEL ALIGNMENT SPECIFICATIONS
.NOTE: Refer to FASTENER NOTICE .
- Tighten the jam nut on the tie rod.
Tighten
Tighten the front tie rod jam nut to 68 N.m (50 lb ft).
- Check the toe setting after tightening.
- Adjust the toe setting if necessary.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.