Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
On-Board Diagnostics: Notes
PCM is equipped with a self-diagnostic system which detects system failures or abnormalities. When a malfunction occurs, PCM will store a Diagnostic Trouble Code (DTC) and, if code is emissions related, illuminate the Malfunction Indicator Light (MIL) located on instrument cluster.
There are 2 paths for accessing on-board diagnostics. It is necessary to access information through both paths, as each path presents some different information.
- Generic OBD-II
This provides all generic codes and some OEM codes, serial data required for generic OBD-II and some OEM data, monitor status, pending codes and freeze frame. - OEM
All DTCs, all PIDs, failure records, enhanced scan tool information and all other OEM scanner functions.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.