SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA RWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1161 (SHIFT INTERLOCK SYSTEM)COMPONENT LOCATORAUTOMATIC TRANSMISSION SHIFT LOCK CONTROL CONNECTOR END VIEWS
2004 Oldsmobile Bravada RWD

Automatic Transmission Shift Lock Control Connector End Views

2004 Oldsmobile Bravada RWDSECTION Automatic Transmission Shift Lock Control Connector End Views
WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
Automatic Transmission Floor Shift Control Connector End View - Pontiac

GM40422Courtesy of GENERAL MOTORS CORP.
Connector Part Information
  • 12064762
  • 6-Way F Metri-Pack 150 Series (GRY)
Pin Wire Color Circuit No. Function
A TAN/WHT 816 A/T Shift Lock Solenoid Control
B ORN/BLK 1786 Ignition 1 Voltage
C LT BLU 1134 Ignition Lock Cylinder Control Actuator Signal
D - - Not Used
E DK GRN/
WHT		 1135 A/T Shift Lock Control Solenoid Supply Voltage
F PPL 1600 Ignition 0 Voltage
A/T Shift Lock Control Solenoid Connector End View - Buick

GM280768Courtesy of GENERAL MOTORS CORP.
Connector Part Information
  • 12052832
  • 2-Way F Metri-Pack 150 (BLK)
Pin Wire Color Circuit No. Function
A DK GRN/WHT 1135 A/T Shift Lock Control Solenoid Supply Voltage
B BLK 816 A/T Shift Lock Control Solenoid Control
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.