Installation Procedure

2004 Oldsmobile Bravada RWDSECTION Installation Procedure
WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Sunroof Module Assembly
    GM741357Courtesy of GENERAL MOTORS CORP.
  1. Position the sunroof module to the vehicle roof with an assistant.
  2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the sunroof module bolts to the sunroof module.

    Tighten:  Tighten the sunroof module bolts to 10 N.m (89 lb in).

  4. Connect the front and rear drain hoses to the sunroof module.
  5. Connect the electrical connector to the sunroof module assembly.
  6. Inspect for proper operation of the sunroof.
  7. Install the headliner. Refer to Headliner Replacement (Rendezvous) or Headliner Replacement (Aztek) in Interior Trim.
  8. Install the sunroof sunshade. Refer to Sunroof Sunshade Panel Replacement .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.