Installation Procedure

2004 Oldsmobile Bravada RWDSECTION Installation Procedure
WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating Sunroof Control Module Retainer Tabs
    GM791684Courtesy of GENERAL MOTORS CORP.
  1. Connect the electrical connectors to the sunroof control module.
  2. Position the control module retainer tabs to the slots in the sunroof module.
  3. Fig 2: Installing Sunroof Control Module
    GM548333Courtesy of GENERAL MOTORS CORP.
  4. Install the control module to the sunroof module by sliding the control module to the right, pressing into place until fully seated.
  5. Inspect for the proper operation of the sunroof.
  6. Install the headliner. Refer to Headliner Replacement (Rendezvous) or Headliner Replacement (Aztek) in Interior Trim.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.