Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA RWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1136 (STATIONARY WINDOW SYSTEM)COMPONENT LOCATORSTATIONARY WINDOWS CONNECTOR END VIEWS
2004 Oldsmobile Bravada RWD
Stationary Windows Connector End Views
2004 Oldsmobile Bravada RWDSECTION Stationary Windows Connector End Views
WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
Inside Rearview Mirror (W/O UE1) Connector End View
| Connector Part Information |
|
||
|---|---|---|---|
| Pin | Wire Color | Circuit No. | Function |
| 1 | YEL | 643 | Accessory Voltage (DD8) |
| 2 | BLK | 650 | Ground |
| 3 | LT GRN | 24 | Backup Lamp Supply Voltage (DD8) |
| 4-5 | - | - | Not Used |
| 6 | GRY/BLK | 690 | Courtesy Lamp Low Control |
| 7 | ORN | 1732 | Courtesy Lamps Supply Voltage |
Rear Window Defogger Grid C1 Connector End View
| Connector Part Information |
|
||
|---|---|---|---|
| Pin | Wire Color | Circuit No. | Function |
| A | DK GRN | 1927 | Rear Defogger Element Supply Voltage (DD8) |
Rear Window Defogger Grid C2 Connector End View
| Connector Part Information |
|
||
|---|---|---|---|
| Pin | Wire Color | Circuit No. | Function |
| A | BLK | 1150 | Ground |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.