Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA RWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1132 (BODY FRONT END)REPAIR INSTRUCTIONSFRONT FENDER LINER REPLACEMENTINSTALLATION PROCEDURE

2004 Oldsmobile Bravada RWD

Installation Procedure

2004 Oldsmobile Bravada RWDSECTION Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.

Position the fender liner to the fender, over the studs and behind the rocker molding.
NOTE: Refer to Fastener Notice in Cautions and Notices.
Install the nut to the stud at the rear of the front fender liner.
Tighten: Tighten the front fender liner rear nut to 10 N.m (89 lb in).

Fig 1: Identifying Rear Fender Liner Rear Stud Nut
Courtesy of GENERAL MOTORS CORP.
Install the nut to the stud at the front of the front fender liner.
Tighten: Tighten the front fender liner front nut to 10 N.m (89 lb in).

Fig 2: Locating Front Fender Liner Rear Stud Nut
Courtesy of GENERAL MOTORS CORP.
Install the screws to the front fender liner at the front bumper fascia and fender.
Tighten: Tighten the front bumper fascia and fender screws to 2 N.m (18 lb in).

Fig 3: View Of Front Fender Liner Retaining Screws
Courtesy of GENERAL MOTORS CORP.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.