Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA RWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1128 (BUMPER SYSTEM)
2004 Oldsmobile Bravada RWD
Section 1128 (Bumper System)
2004 Oldsmobile Bravada RWDSECTION Section 1128 (Bumper System)
WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
- Specifications
- Diagnostic Information and Procedures
- Repair Instructions
- Fascia Replacement - Front Bumper - Upper (Aztek)
- Fascia Replacement - Front Bumper - Upper (Rendezvous)
- Fascia Replacement - Front Bumper - Lower (Aztek)
- Fascia Replacement - Front Bumper - Lower (Rendezvous)
- Fascia Grille Replacement (Aztek)
- Fascia Grille Replacement (Rendezvous)
- Fascia Support Replacement - Front Bumper Upper
- Impact Bar Replacement - Front Bumper
- Energy Absorber Replacement - Front (Aztek)
- Energy Absorber Replacement - Front (Rendezvous)
- Fascia Replacement - Rear Bumper (Aztek)
- Fascia Replacement - Rear Bumper (Rendezvous)
- Energy Absorber Replacement - Rear (Aztek)
- Energy Absorber Replacement - Rear (Rendezvous)
- Impact Bar Replacement - Rear Bumper
- Special Tools and Equipment
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.