Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Disabling Procedure
2004 Oldsmobile Bravada RWDSECTION Disabling Procedure
WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Refer to SIR Service Precautions .
- Turn the steering wheel so that the vehicle's wheels are pointing straight ahead.
- Turn OFF the ignition.
- Remove the key from the ignition switch.
- Remove the console accessory wiring junction block access hole cover.IMPORTANT: With the SIR Fuse removed and the ignition ON, the AIR BAG indicator illuminates. This is normal operation, and does not indicate an SIR system malfunction.
- Remove the SIR Fuse.
- Remove the LH insulator panel.
- Remove the connector position assurance (CPA) from the inflatable restraint steering wheel module coil connector (1) located at the base of the steering column.
- Disconnect the steering wheel module coil connector.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.