Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA RWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1118 (ENGINE CONTROLS - 3.4L - INTRODUCTION - SERVICE & REPLACEMENT)REPAIR INSTRUCTIONSACCELERATOR CONTROLS CABLE BRACKET REPLACEMENTINSTALLATION PROCEDURE
2004 Oldsmobile Bravada RWD
Installation Procedure
2004 Oldsmobile Bravada RWDSECTION Installation Procedure
WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
- Position the accelerator cable bracket on the throttle body.
- Install the nut (3) and bolts (1, 2).
Tighten:
- Tighten the bolts in sequence (2, 1) to 13 N.m (115 lb in).
- Tighten the nut in sequence (3) to 10 N.m (89 lb in).
- Connect the cruise control cable into accelerator cable bracket.
- Connect the accelerator cable to the throttle body lever.
- Connect the cruise control cable to the throttle lever and accelerator bracket, if applicable.
NOTE:
Refer to Fastener Notice in Cautions and Notices.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.