Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
2004 Oldsmobile Bravada RWDSECTION Installation Procedure
WARNING: This page is about a different car, the 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
- Install the EVAP canister (3). Refer to Evaporative Emission (EVAP) Canister Replacement .
- Install the EVAP vent solenoid valve (2). Refer to Evaporative Emission (EVAP) Canister Vent Solenoid Valve Replacement .
- Install the fuel pipes to the fuel tank.
- Install the fuel tank wiring harness to the fuel tank.
- Install the fuel sender (1). Refer to Fuel Tank Module Replacement .
- With the aid of an assistant or a transmission jack, position and support the fuel tank.
NOTE:
Do not bend the fuel tank straps. Bending the fuel tank straps may damage the straps.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.