SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA RWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1111 (CRUISE CONTROL SYSTEM)COMPONENT LOCATORCRUISE CONTROL CONNECTOR END VIEWS
2004 Oldsmobile Bravada RWD

Cruise Control Connector End Views

2004 Oldsmobile Bravada RWDSECTION Cruise Control Connector End Views
WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
Cruise Control Module (LA1) Terminal End View

GM570216Courtesy of GENERAL MOTORS CORP.
Connector Part Information
  • 12065425
  • 10-Way F 150 Series (BLK)
Pin Wire Color Circuit No. Function
A GRY 397 Cruise Control On Switch Signal
B DK BLU 84 Cruise Control Set/Coast Switch Signal
C GRY/BLK 87 Cruise Control Resume/Accel Switch Signal
D BRN 86 Cruise Control Release Signal
E BLK/WHT 451 Ground
F PNK 39 Ignition 1 Voltage
G WHT 17 Stop Lamp Switch Signal
H DK GRN 83 Cruise Control Inhibit Signal
J WHT 85 Cruise Control Engaged Signal
K DK GRN 389 Vehicle Speed Signal
Turn Signal/Multifunction Switch C4 (K34) Terminal End View

GM39661Courtesy of GENERAL MOTORS CORP.
Connector Part Information
  • 12047786
  • 4-Way M 150 Series (BLK)
Pin Wire Color Circuit No. Function
A PNK 39 Ignition 1 Voltage
B GRY 397 Cruise Control On Switch Signal
C GRY/BLK 87 Cruise Control Resume/Accel Switch Signal
D DK BLU 84 Cruise Control Set/Coast Switch Signal
Cruise Control Release Switch (LA1) Terminal End View

GM287957Courtesy of GENERAL MOTORS CORP.
Connector Part Information
  • 12041433
  • 2-Way F Metri-Pack 280 Series (BLK)
Pin Wire Color Circuit No. Function
A BRN 86 Cruise Control Release Signal
B PNK 39 Ignition 1 Voltage
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.