Scan Tool Output Controls

2004 Oldsmobile Bravada RWDSECTION Scan Tool Output Controls
WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
Body Control Module Scan Tool Output Controls

Scan Tool Output Control Additional Menu Selection(s) Description
Driver Door Unlock Door Lock Test The BCM actuates the driver door lock actuator for approximately 5 seconds when you select ON. The driver door should unlock.
Passenger Door Unlock Door Lock Test The BCM actuates the front passenger, LR and RR door lock actuators for approximately 5 seconds when you select ON. All of the doors, except the driver door, should unlock.
Door Lock Door Lock Test The BCM actuates all of the door lock actuators for approximately 5 seconds when you select ON. All of the doors should lock.
Memory Seat Module Scan Tool Output Controls

Scan Tool Output Control Additional Menu Selection(s) Description
Mirror Left/Right Left Mirror Test The driver mirror is commanded to rotate left or right for approximately 5 seconds when you select Left or Right. The driver mirror should move left or right as selected.
Mirror Left/Right Right Mirror Test The passenger mirror is commanded to rotate left or right for approximately 5 seconds when you select Left or Right. The passenger mirror should move left or right as selected.
Mirror Up/Down Left Mirror Test The driver mirror is commanded to rotate up or down for approximately 5 seconds when you select Up or Down. The driver mirror should move up or down as selected.
Mirror Up/Down Right Mirror Test The passenger mirror is commanded to rotate up or down for approximately 5 seconds when you select Up or Down. The passenger mirror should move up or down as selected.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.