Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Freeze Frame/Failure Records
PCM stores one freeze frame record for the first failed test that sets a DTC and illuminates MIL. Freeze frame will not be overwritten unless a misfire or fuel trim DTC is set. Failure records are stored when any DTC is set. Some PCMs can store up to 5 failure records. Failure records will be stored for all types of codes, whether or not the MIL is illuminated.
Typical data includes:
- Air/fuel ratio.
- Airflow rate.
- Fuel trim.
- Engine speed.
- Engine load.
- Engine coolant temperature.
- Vehicle speed.
- Throttle position angle.
- Manifold absolute pressure.
- Injector base pulse width.
- Loop status.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.