Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA RWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 109 (ENGINE CONTROL SYSTEM SELF-DIAGNOSTICS - 3.4L)PROGRAMMINGENGINE OIL LIFE RESET
2004 Oldsmobile Bravada RWD
Engine Oil Life Reset
2004 Oldsmobile Bravada RWDSECTION Engine Oil Life Reset
WARNING: This page is about a different car, the 2002 Pontiac Grand Am, 2002 Oldsmobile Alero, 2002 Chevrolet Monte Carlo, and 2002 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
Using Radio
- Turn the ignition to ACC OR ON, with the radio off.
- Press and hold the TUNE DISP button on the radio for at least five seconds until SETTINGS is displayed.
- Press the SEEK PTYPE or the SEEK PSCAN up or down arrow to scroll through the main menu.
- Scroll until OIL LIFE appears on the display.
- Press the 1 PREV or 2 NEXT button to enter the sub menu. RESET will be displayed.
- Press the TUNE DISP button to reset. A chime will be heard to verify the new setting and DONE will be displayed for one second.
- Once the message has been reset, scroll until EXIT appears on the display.
- Press the TUNE DISP button to exit programming. A chime will be heard to verify the exit.
Using Accelerator Pedal
- Turn ignition to ON, with engine off.
- Fully press and release accelerator pedal 3 times within five seconds. If CHANGE ENGINE OIL message flashes, the system is reset. However, if it stays on, it did not reset. Repeat the procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.