Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA RWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 108 (ENGINE CONTROL SYSTEM SELF-DIAGNOSTICS - 3.8L)SYSTEM TESTSMIL INOPERATIVEMIL OPERATION
2004 Oldsmobile Bravada RWD
MIL Operation
2004 Oldsmobile Bravada RWDSECTION MIL Operation
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 Pontiac Grand Prix, 2002 Pontiac Bonneville, 2002 Chevrolet Monte Carlo, 2002 Chevrolet Impala, and 2002 Buick Regal. However, it is still accessible from the selected car via links, so may be relevant.
The MIL is located on the instrument panel.
MIL Function
- The MIL informs the driver that a malfunction has occurred and the vehicle should be taken in for service as soon as possible.
- The MIL illuminates during a bulb test and a system test.
- A Diagnostic Trouble Code (DTC) will be stored if a MIL is requested by the diagnostic.
MIL Illumination
- The MIL will illuminate with ignition switch on and the engine not running.
- The MIL will turn off when the engine is started.
- The MIL will remain on if the self-diagnostic system has detected a malfunction.
- The MIL may turn off if the malfunction is not present.
- If the MIL is illuminated and then the engine stalls, the MIL will remain illuminated so long as the ignition switch is on.
- If the MIL is not illuminated and the engine stalls, the MIL will not illuminate until the ignition switch is cycled off, then on.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.