Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA RWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 108 (ENGINE CONTROL SYSTEM SELF-DIAGNOSTICS - 3.8L)INSPECTION/MAINTENANCE PROCEDURESINSPECTION/MAINTENANCE HEATED OXYGEN SENSOR/OXYGEN SENSOR SYSTEM SET PROCEDUREPROCEDURE
2004 Oldsmobile Bravada RWD
Inspection/Maintenance Heated Oxygen Sensor/Oxygen Sensor System Set Procedure: Procedure
2004 Oldsmobile Bravada RWDSECTION Procedure
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 Pontiac Grand Prix, 2002 Pontiac Bonneville, 2002 Chevrolet Monte Carlo, 2002 Chevrolet Impala, and 2002 Buick Regal. However, it is still accessible from the selected car via links, so may be relevant.
- Perform INSPECTION/MAINTENANCE SYSTEM CHECK . After performing inspection/maintenance system check, go to next step.
- Verify vehicle is operating within Conditions for Running. Turn off all accessories. Start and idle engine. Accelerate at part throttle to 45-55 MPH. Maintain this speed for 6 minutes or until I/M SYSTEM STATUS updates to YES. M/T may require operation in 4th or 5th gear. Using scan tool, review I/M SYSTEM STATUS display. If HO2S SYSTEM STATUS update to YES, go to step 5. If HO2S SYSTEM STATUS does not update to YES, go to next step.
- Using scan tool, observe DTC information. If scan tool indicates any failed DTCs, see DIAGNOSTIC TROUBLE CODE INDEX table under DIAGNOSTIC TROUBLE CODE DEFINITIONS. If scan tool does not indicate any failed DTCs, go to next step.
- Using scan tool, observe NOT RAN SINCE CODE CLEARED display to determine if DTCs P0133, P0140, P1133 and P1134 have run. For those DTCs that have not run, see Conditions for Running DTC in appropriate DTC under DIAGNOSTIC TESTS. Operate vehicle to meet code enable criteria until DTC(s) runs. Using scan tool, observe I/M SYSTEM STATUS display. If HO2S SYSTEM STATUS updated to YES, go to next step. If HO2S SYSTEM STATUS did not update to YES, see DIAGNOSTIC AIDS .
- Using scan tool, check for DTCs. If scan tool indicates any DTCs are set, see DIAGNOSTIC TROUBLE CODE INDEX table under DIAGNOSTIC TROUBLE CODE DEFINITIONS.
CAUTION:
Road test vehicle under safe conditions and while obeying all traffic laws. Do not attempt any maneuvers that could jeopardize vehicle control. Failure to adhere to these precautions could lead to serious personal injury and vehicle damage.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.