SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA RWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 108 (ENGINE CONTROL SYSTEM SELF-DIAGNOSTICS - 3.8L)DIAGNOSTIC TESTSDTC P0325: KNOCK SENSOR MODULE CIRCUITDIAGNOSTIC PROCEDURES
2004 Oldsmobile Bravada RWD

Diagnostic Procedures

2004 Oldsmobile Bravada RWDSECTION Diagnostic Procedures
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 Pontiac Grand Prix, 2002 Pontiac Bonneville, 2002 Chevrolet Monte Carlo, 2002 Chevrolet Impala, and 2002 Buick Regal. However, it is still accessible from the selected car via links, so may be relevant.
  1. Perform Diagnostic System Check - Engine Controls. See DIAGNOSTIC SYSTEM CHECK - ENGINE CONTROLS  under SELF-DIAGNOSTIC SYSTEM. After performing Diagnostic System Check - Engine Controls, go to next step.
  2. Observe FREEZE FRAME/FAILURE RECORDS data for this DTC. Turn ignition off for 30 seconds. Start engine. Operate vehicle within Conditions for Running DTC or as close to Freeze Frame/Failure Records data as possible. Does the DTC fail this ignition cycle? If yes, go to next step. If no, see INTERMITTENT CONDITIONS  under SELF-DIAGNOSTIC SYSTEM.
  3. Replace PCM. Program replacement PCM. See POWERTRAIN CONTROL MODULE  under PROGRAMMING. After repairs, go to next step.
  4. Using scan tool, clear DTCs. Turn ignition off for 30 seconds. Start engine. Operate vehicle within Conditions for Running DTC. Does DTC run and pass? If yes, go to next step. If no, go to step  2.
  5. Using scan tool, observe stored information. Does scan tool displays any DTCs that have not been diagnosed? If yes, see DIAGNOSTIC TROUBLE CODE DEFINITIONS . If no, system is okay.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.